After Edwin's LPC, Do I need to adjust LP?

[Sporkie16]

Hi, i just purchased a LPC (Just Chamber) From Edwin, and i was wondering two things.


how do i check the low pressure with the chamber on?

1) If i adjust without the chamber using the gauge, then put the chamber on, will my settings stay or be thrown off because of increased volume?

2) Can i use that little hole ( bottom left of aoc cap) to attach a gauge?
- this would be nice as i can adjust pressure while having the chamber on.


Thanks guys.

[usagi_tetsu]

Actually, I like using that little hole to check my pressure over the classic ram/AOC pressure gauge no matter what setup I'm using. Just get an appropriate size barb to screw in there (anyone wanna help me with the size on that one, I don't have it to hand, thanks!), some microline hose, and a gauge with a single barb on it as well, and you're all set!

[Edwin]

The LPC will not effect the LP. You will just have more volume of air to draw from.

What the LP will do:
1. Give more volume to keep your marker from 'starving' it's LP supply during higher BPS.
2. Enable lower pressure operation so you can help with chopping balls.

Both can be accomplished at the same time. You will need to fiddle with the LP to get it just right.

I would set to 80psi and see how it runs there.


P.S. Make sure your marker is running perfectly before you start you LPC/LP tweaking. If you have bad efficency, FSDO, or any other problems with your marker, messing with the AOC/LP will only cause more headaches!!!!

[Edwin]

#2 Yes you can---it is an 8-32 barb that you can get from me or ASP (maybe others).

http://www.tribal-paintball.com/edwin247/somethingodd.jpg

[Sporkie16]

You Guys are un-beleivable!

Thank you so much for the help.

if not for you, these guns would be dead.

(It is nice that no one knows what they are, and they automaticly think they are crap)