HPR asa

[bakerboy4679]

http://i133.exs.cx/img133/3557/inlineasa8rq.th.jpg (http://img133.exs.cx/my.php?loc=img133&image=inlineasa8rq.jpg)

When you put on a LPR, do you just get this drilled/tapped? or does someone sell them tapped? also, are the LPR threads(when tapped) autococker LPR fittable? I have a Tickler..

[warpedmephisto]

You can either go the LPR adapter route, or drill/tap the asa. ASP has some MacDev ones or you can drill and tap the stock one yourself. The threads are 1/8"-27 NPT and are the same thread as 'Cocker LPRs.

[Edwin]

Quick note.

If your doing it yourself, make sure you drill in the right spot!!! Too high and you hit the ASA screw, too low and your HPR will not seal!!!

Also you want to be really careful getting it drilled and tapped square to the ASA as it will look real funny poking up or out the side!!! :)

It isn't the easiest process. I made a jig just for drilling and tapping!!!

[bakerboy4679]

i wasnt planning on doing myself, but i would like it to be done. i'm just trying to see the future(for now i'll just put a gauge iin there, later possibly a LPR)