Chaos Install Questions

[tolar250]

i bought a 2007 universal chaos kit from vaporworks but it didn't come with any kind of documentation. i was expecting at least a pin out. but any way i got most of the wiring figured out except for the eyes and microswitch. i know the eyes and the microswitch wire together but i'm not sure how. on the pigtail i got with the kit at the microswitch pin theres 3 wires coming off of it. and the microswitch has 3 pins, so one wire to each pin? does it matter which wire goes where? does it matter which pins on the microswitch the the eyes splice into?

heres what i got so far
http://i35.photobucket.com/albums/d161/tolar250/tribalwiringharness.jpg

[tolar250]

ok i think i got it figured it out heres what i got now
http://i35.photobucket.com/albums/d161/tolar250/tribalwiringharness-3.jpg
i just want to make sure this is right before i start soldering

thanks

[shiftycastro]

if they dont answer here ....email or pm warped or edwin

[Edwin]

This won't help much, but it is a try.

http://www.tribal-paintball.com/edwin247/tribal/harness.jpg

I have a wiring diagram for the Tribal, but it is written in a notebook and not on electronic media. I will see what I can do if you can't figure it out.

[tolar250]

thanks i soldered everything together tonight minus the eyes cause i'm not installing them at this time and it all appears to work. the main thing that was confusing me was the three wires coming off of the board connector. from what i've seen everything is usually soldered together at the microswitch.