AOC...grr... help ??

[_MaD_]

Been working on those sick tribals. One is fine mechanically and the only problem on the other I have narrowed down to the AOC. Gas it up with a guage on the front and it quickly bottoms out my 200PSI guage (assuming it's going higher)..

What I've done:
- Replaced the O-rings. The old ones looked fine too.
- The little O-ring inside the AOC body for the plunger looks fine.
- Swapped AOC into another gun. Problem follows the AOC. AOC from the other gun (the good one) works fine in either.

I believe the problem is the seat / seal on the AOC that the tip of AOC plunger pushes against. It looked bad.. I tried to nudge it out and flip it, but I suspect I only made it worse.

Couple questions...
- Does that sound like it could be the issue?
- Thoughts on how to replace that seal?
- Anyone have a stock AOC they want to give up cheap? :)

I know the easiest solution would be to nab one of Edwins (or ASPs) awesome AOC replacements... and I've HATED the stock ones since day 1.... but I was mainly trying to restore, not upgrade. :\

[shiftycastro]

It does sound like a AOC issue.... not sure on the seal.
I have a few extra (20 or so) send me addy threw a PM and I will try to get it out to you tomorrowish

[~kaos~]

Yeah, when it gets to that point and you can't dig out that seal and flip it yer pertty much at an end with that particular piece. Looks like Shifty has the cheapest solution covered for you tho.....