PDA

View Full Version : My 2 tribals..

Etipp98
12-10-2008, 09:05 PM
Here are my two currently, I am making custom adapter plates to fit the ripper and sonic bushy frames with electronics. My stock frames and electronics are available if anyone wants them for a small fee.
http://i33.tinypic.com/28hzaxl.jpg
Spitlebug
12-10-2008, 09:15 PM
Why a Ripper and Sonic frame? IMHO, the T2 Gripframe or the 2k4 Gripframe are the nicest ICD frames out there.
Etipp98
12-10-2008, 10:27 PM
The T2 trigger is hard to walk, and I got them for pretty cheap.
~kaos~
12-11-2008, 01:27 AM
Did you consider maybe keeping the stock frames and just doing a 2x trigger & guard mod? If you're handy with tools it's not hard to do... here's a couple I've done:

http://i199.photobucket.com/albums/aa229/mrfngolf/11frame001.jpg

http://i199.photobucket.com/albums/aa229/mrfngolf/blkfluster.jpg
Etipp98
12-11-2008, 04:22 PM
Thing is, the electronics in the blue/black twister were bad, so I tried to just throw all the bushy electronics into it but could not get the microswitch pins out of the frame.The bushy board is also too big to fit in the grip along with the battery so I am just going to go this route instead.
Spitlebug
12-11-2008, 05:15 PM
If you have a 9300 board, you can cut the bottom half of it off making sure to leave some of the un-etched (light green) trace at the bottom of the board. You can get the size down to about 1.1" long.
~kaos~
01-28-2009, 02:06 AM
If you have a 9300 board, you can cut the bottom half of it off making sure to leave some of the un-etched (light green) trace at the bottom of the board. You can get the size down to about 1.1" long.
I've done that exactly.... and a few other things.