dudeyort
07-29-2009, 02:41 AM
Been a while since I visited the boards… and even longer since I used my Mephy… actually, I’ve not used it since I got it back from Warped years ago for a host of upgrades/
I wasn’t sure which chip/board I had installed, but it appears to be a Chaos… I know Andy installed it but I can’t recall where I bought it.
Anyhow, I'm wondering about the trigger set configuration. I read through the manuals posted on Vaporwork's site, and my led doesn't flash in a pattern when I hold the trigger and turn it on, it just stays "steady on".
I think, since there is no jumper on my “tourney lock” pins, that they may be touching part of the frame when it's installed thus completing a circuit to put it in "tourney lock". Would tourney lock mode give a steady led when holding the trigger on power up? Or might I have something else going on?
Just curious… gun seems to work fine, and it sure rips better than I remembered.
Thanks,
Troy
I wasn’t sure which chip/board I had installed, but it appears to be a Chaos… I know Andy installed it but I can’t recall where I bought it.
Anyhow, I'm wondering about the trigger set configuration. I read through the manuals posted on Vaporwork's site, and my led doesn't flash in a pattern when I hold the trigger and turn it on, it just stays "steady on".
I think, since there is no jumper on my “tourney lock” pins, that they may be touching part of the frame when it's installed thus completing a circuit to put it in "tourney lock". Would tourney lock mode give a steady led when holding the trigger on power up? Or might I have something else going on?
Just curious… gun seems to work fine, and it sure rips better than I remembered.
Thanks,
Troy