PDA

View Full Version : Microswitch

bakerboy4679
03-22-2005, 04:59 PM
I was thinking about when i get my microswitch in from ASP.
Is there any soldering involved?
jeremy.sears
03-22-2005, 05:07 PM
yes, two wires
bakerboy4679
03-22-2005, 05:10 PM
ok.. well it looks like a might just buy Smegle5's prewired board.. so nvm on this thread.. but i do have one question still:

I heard of people flipping there switchs upside down, to make them more sensitive.. does this work? and will the pins line up alright?
bakerboy4679
03-23-2005, 07:03 PM
If you flip the microswitch, does it make it more responsive? Does it have effects(bad)
Asbestos
05-07-2005, 03:02 PM
It works in other guns, but not in tribals.
If you look at your two microswitch pins on the side you will se that they form about a 45 degree angle. Therefor flipping the microswitch ends in no real net gain, your trigger set screw hits it in the same place. In other guns the switch is at 90 or 180 degrees and the screw hits it right on top of the button, instead of on the (second class) lever (which results in less forcer required).