Jakesak
03-01-2005, 08:17 PM
Removeing the valve:
Take out the aoc(look for the thread about "putting on a LPR") take off the trigger frame. Remove the brass screw on the bottom of the body. This will free up the valve, but it might still not come out. If so then remove the ram(look above) get a stick with soft piece on the end.( pencils might work, as well as just a dowel rod with rubber at the end). Push out from the ram, so that the valve exits from the front of the gun. Do what you must to it. Replacing it. Put it back in so that the groove matches with the bottom of the body where the screw is. Put the brass looking screw in and you might want to use teflon or loctite on this. Replace all the interenals.
Take out the aoc(look for the thread about "putting on a LPR") take off the trigger frame. Remove the brass screw on the bottom of the body. This will free up the valve, but it might still not come out. If so then remove the ram(look above) get a stick with soft piece on the end.( pencils might work, as well as just a dowel rod with rubber at the end). Push out from the ram, so that the valve exits from the front of the gun. Do what you must to it. Replacing it. Put it back in so that the groove matches with the bottom of the body where the screw is. Put the brass looking screw in and you might want to use teflon or loctite on this. Replace all the interenals.