Jakesak
03-01-2005, 08:21 PM
Putting a LPR on:
First take off the aoc cover. Next remove the asa screw. Now take out the plunger with amost any screw (bottomline screws work). If the aoc comes out good, if not take out the spring and aoc any way you know how. Next there will be a valve spring to take out.
Then take out the grub screw in front. Use an allen key. NOTE: most will be loctited in, YOU WILL NEED HEAT to get it out. Then replace it with what appears to be a cocker hose nipple, but with a different thread size.
Then put the spring back in put that back in. Now with the LPR adapter, put it so that the spring is on the threading and against the valve stem. Screw the adpator in all the way. Now put the LPR onto the adpater and connect the hose to the gun. Put the ASA back on. and you are set.
NOTE: use teflon tape/loctite where needed.
First take off the aoc cover. Next remove the asa screw. Now take out the plunger with amost any screw (bottomline screws work). If the aoc comes out good, if not take out the spring and aoc any way you know how. Next there will be a valve spring to take out.
Then take out the grub screw in front. Use an allen key. NOTE: most will be loctited in, YOU WILL NEED HEAT to get it out. Then replace it with what appears to be a cocker hose nipple, but with a different thread size.
Then put the spring back in put that back in. Now with the LPR adapter, put it so that the spring is on the threading and against the valve stem. Screw the adpator in all the way. Now put the LPR onto the adpater and connect the hose to the gun. Put the ASA back on. and you are set.
NOTE: use teflon tape/loctite where needed.