Anyone have a good idea for getting the AOC body out?

[P-Train]

I finally got around to adjusting my gun, and i need to turn the AOC pressure up. Problem is, i cant get the stupid thing out. Any ideas?

[warpedmephisto]

Talk to me tomorrow at school and we can set some time up and I can show you the ropes if you want.

[k.macocker]

Assuming you don't have a tool and need something like the tool. I did this with my first tribal that did not have tools.
Take a thick metal coat hanger and bend it into a u shape that is about 1" tall when stood up like the letter U. If you use a thin wire coat hanger it will bend and twist in the holes damaging the holes in the AOC cap. I did this many many times with my old tribe and never damaged anything at all. The first time I used a pair of needle nose to grap the U tool I made for turning leverage. I grabbed the U as close to both tips as possible after sticking it into the aoc.
good luck,
Kmac

[outreach]

buy one of those screws edwin has that does not block the bottom tub then tack the cap off and let alittle air through dont air your gun up all the way you need an on off and a screw from edwin to do this method

[Slider25]

Wouldn't the air just leak out? First check and see if the aoc was damaged by the asa screw. I had to push mine out with the valve because someone had damaged mine right where the oring was and it was jammed tight! Luckly I was replacing it with Edwin's LPRC (awsome upgrade) because it was beyond repair! Good luck.

[outreach]

no there is still metal there so the air will push against it

[Slider25]

that would make sense because the cap does not have to be sealed. Didn't think it through.