takes a few seconds..

[bakerboy4679]

My bbt: has a stock V1E board w/ Fury Chip, and rewired by Andy.
The back LED's dont work(red, yellow and green), but the side(red one) LED does.

It takes my selenoid about 3 seconds to start clicking/fireing.
Is this normal?

[Edwin]

Do you have that insulator between the body and the grip frame?
New Battery?
Check all wire to see if they broke loose.

[bakerboy4679]

insulator yes, after i just redid my internals i realized it wasnt there, i replaced it.(hadnt been on for o.. say 100shots or so)

new battery no

wires i doubt anythings broke, i just looked over them an didnt see any bad..

[Edwin]

Alway check with a new battery....

If you didn't have an insulator, you could have been shorting out the batt.

[bakerboy4679]

ok, as long as it wasnt shorting out the board in any way. I'll try a new battery today sometime(I hate how expensive they are!! lol)

[shiftycastro]

i know my fury chips would do that....... when you turn on to fire you have a little delay then it fires just fine.

i always thought it was something with the fury because both of mine did that

[warpedmephisto]

Yep, the Fury chip has a little delay built into before you can start firing. It was used for the Mephisto so you could tell what mode you were and so you could program it via the trigger.

[bakerboy4679]

It was used for the Mephisto so you could tell what mode you were and so you could program it via the trigger.

Is there a diagram on how to adjust the settings of the Fury chip?
How many settings are there?

I've been wondering why my dipswitches didnt work, then I realized/remembered taht I had a Fury chip in there.. does the fury stop these from working???

sorry about the old thread, just readin up on some old things.. to refresh my memory/ maybe even learn soething I've overlooked!!

~Andrew

[jeremy.sears]

go to ASP and the tribal accesories then at the bottom where you can buy the fury chip, there is a link to the manual (its like a page or two I think)

[goose]

i have a similar situation with my furry chip in my twister 2.0
the red led on the back and side no longer comes on instead the yellow one on the back comes on...now if i take the fury out and put the stock one back in the the red leds work again....funky

[warpedmephisto]

Yeah, its just the pinout of the chip. I have been just bridging a pin off of the IC to the ground and it makes the LED work again. I think the Fury chip was designed only to work based off of the v2b boardset, not the v1e's, etc.

[Sporkie16]

What pin did you ground and what is the best way? WARNING: I AM AN EXTREME NOOB.

[warpedmephisto]

If you don't know how to solder well I wouldn't suggest attempting to ground the pin out on the board.