moppedclean
10-01-2005, 04:19 PM
I've been having a weird problem with my detents lately. I currently have a Morlock board in my Tribal. If any of you have a Morlock board, you know that when the eyes "see eachother" in eye mode, the board waits 3/4 second and then fires, because it is assuming that you are dry firing. The problem was, it was going in to this mode during the middle of firing w/ a fully working halo. So this made no sense, because that means that it didn't detect a ball, when there clearly was a ball in the breech. So one time I was firing full auto, and it just stopped. I took off the barrel and sure enough the ball was lodged in between the detent and the other side of the breech. So that one wasn't detected by the eyes and the next ball didn't have enough room to fall either. You would think that this is an odd situation and it would rarely happen, but suprisingly it happens pretty often. And also, I know for sure that it isn't "rollback" because I tested it to see if the eyes would detect a ball fully rolled back in to the bolt, and they did.
Has anyone had this problem, or does anyone know a good solution? Maybe the halo is pushing the balls down too hard? I could maybe oil the drive belt inside the halo so it slips when it's pushing too hard. Any help or suggestions would be appreciated.
Has anyone had this problem, or does anyone know a good solution? Maybe the halo is pushing the balls down too hard? I could maybe oil the drive belt inside the halo so it slips when it's pushing too hard. Any help or suggestions would be appreciated.